Main > Main Forum
How to program new MiniPac?
(1/2) > >>
Blanka:
I just installed a new minipac (the mini USB port UHID lookalike version), and it does not work with the WiniPac utility. I get an error "Failed to program device" error, after which the unit does not work any more until I replug it into the USB port. I also tried the U-config utility (as it looks like a UHID), but that one does not recognize the board at all. Do we need a new utility for the new MiniPAC?
Trap:
I had this same problem when we built my friend's cabinet.  We ended up just making the default settings work.  Are you using Vista by chance?  I was having all sorts of trouble trying to install both winIPAC and the U360 software on his cabinet running Vista. 
chill:
I had the same issue trying to use Win 7.
find an XP machine and it should be ok.


Blanka:
It is running on XP,
I'll see if I can hook it to a Mac.
Blanka:
MacIpac can program the new MiniPac, but not the shift function. :(
I see it works partly as the changes in non-shift buttons are uploaded, where the shift ones don't

The DOS application under XP works but gives a time-out error when choosing program.

Tried WiniPac again, after programming, you get an error, and the whole controlpanel goes "offline" until you reboot.
Navigation
Message Index
Next page

Go to full version