Main > Main Forum

Cutting Holes In Metal Control Panel

Pages: << < (2/2)

Franco B:

1 1/8"  for most Happ style buttons (player and start)

30mm for most Japanese player buttons and 24mm for the start buttons.

For your joystick hole you can just use whatever size you use for the buttons.



Darren01274:

Thanks for the replys guys  8)

jasonbar:

I used a 1-1/8" hole saw on my metal & wood panels.  Use a slow RPM use lots of cutting oil when cutting metal.  (Hopefully this a bare metal panel & not populated with controls & with an overlay.)

-Jason

tommyinajar:

Are you going to leave it plain? I was thinking of doing this and then powder coating it at home with an old oven and a harbor freight powder coat gun.

Pages: << < (2/2)

Go to full version