| Main > Main Forum |
| Tornado spinner |
| (1/1) |
| deadmoney5:
I'm trying to move my Tornado spinner to a more convenient spot on the control panel, but I am having a hell of a time removing the spinner top. I remember there were 2 small screws that you screwed in with allen wrenches to hold the top in place. Now I can't get them out. Before I strip them too much...can one of you tell me the size of those screws? None of mine seem to fit. thanks |
| mytymaus007:
not sure the exact size but radio shack sells the allen key set and one of them will fit. or you can take a sledge hammer and knock it off either way you'll ruin it. might as well have fun doing it :laugh2: |
| Hoopz:
Can you remove anything from the bottom of the shaft to allow you to pull the knob and shaft up without removing the knob? I don't have a Tornado, but that may be an option. :dunno I have a Tron spinner and after screwing around with it like you (no pun intended), someone pointed out that I didn't have to do it that way.... |
| eds1275:
looks like you are using imperial wrenches. Or if you aren't, maybe you are using metric and it takes imperial. In some cases what I have done is use a jeweler's blade screwdriver in an allen nut - one that tapers in [towards the point] so I can get it inside where the wrench should go. But I'd say use this as a last resource. |
| Navigation |
| Message Index |