Main > Main Forum
Velcro!
<< < (2/3) > >>
jasonbar:
Velcro is great & will be plenty strong to hold your panel in place.

There might be difficulty in removing your Velcroed-on panel, however, depending on how you set things up.

Velcro is difficult to pull apart when you're pull the 2 halves straight apart from each other (in a direction normal to the plane of the Velcro).

Velcro comes apart very easily when you peel it (like Velcro sneaker "laces").

If you can remove your panel by a sort of tilting/rolling motion, you'll have better luck.


But, just go ahead & try it & find out--it's easy to test it out!


Good luck--sounds like a great idea.

-Jason
delta88:
Do it says this old timer.

If you dont like the results it was less destructive then mounting clamps and such.
Epyx:
Velcro works just fine.  To assist you in remove a velcro'd CP...use a credit card to slide between the layers and detach, works quick that way.
Jawn:
Just wanted to say thanks to all who responded. Definitely gonna try some different set ups with it to see which works best.
nick3092:
Velcro works very well for mounting a cp. I'm building a modular panel like Doc's, but didn't want the hassel of aligning dowl pins and holes. I went into it thinking it might not work, but all the panels hold securely. Just make sure you prime/paint the MDF where the Velcro will stick to. 
Navigation
Message Index
Next page
Previous page

Go to full version