| Main > Main Forum |
| Andy, where are the Ultimarc Aimtrack guns?! |
| << < (14/15) > >> |
| FrizzleFried:
Sooo... any ETA on a "plug n play" solution? |
| jasonbar:
--- Quote from: AndyWarne on July 26, 2010, 08:32:53 am ---The disk being offset will only be a problem if the adhesive ring used to secure it is also off-center and blocking the sensor. If you just pull it off you can check this, it will easily re-stick. --- End quote --- Thanks for the quick response. I pulled off the (assumed) IR Filter & the adhesive donut it off-center but I can still (barely) see a small hole on the sensor surface--I presume that's the actual sensor hole through which light passes? The adhesive donut is awful close to it but not blocking it straight-on. Any harm in pushing the donut gently & slightly away from the sensor hole? Thanks, -Jason |
| releasedtruth:
Is the LED still going to have a possible housing? I don't have any place I can mount it without something cleaning things up visually. I'm definitely looking forward to getting a pair. |
| AndyWarne:
--- Quote from: releasedtruth on August 15, 2010, 05:20:04 pm ---Is the LED still going to have a possible housing? I don't have any place I can mount it without something cleaning things up visually. I'm definitely looking forward to getting a pair. --- End quote --- Yes. There was a delay on this owing to sourcing the required infra-red moulding material but should be available in a couple of weeks. Andy |
| releasedtruth:
That's fantastic. I'd expect nothing less from Ultimarc. |
| Navigation |
| Message Index |
| Next page |
| Previous page |