Main > Main Forum

Received my new panel, but need a little help

Pages: (1/2) > >>

shateredsoul:

So when I place the joystick over the wood (3/4") just too see how it looks and the happ 8 way sticks out but not as much as i'd like it to stick about as much as in this joysticks



but when I place it to test it out, it sticks only enough for the rubber part to stick out, how can I make it more like in the pic?

TheGameFan:

If I'm reading you're question correctly, the answer is that you need to route a groove for the base in the bottom of the CP. THis will bring the stick higher. Also, there is a spacer that you cna use to raise it a bit.

DashRendar:


--- Quote from: shateredsoul on May 18, 2010, 08:22:57 pm ---So when I place the joystick over the wood (3/4") just too see how it looks and the happ 8 way sticks out but not as much as i'd like it to stick about as much as in this joysticks but when I place it to test it out, it sticks only enough for the rubber part to stick out, how can I make it more like in the pic?

--- End quote ---

Holy run-on sentence, Batman!  Throw some punctuation in there!  :lol

syph007:

It's probably bottom mounted right?  Top mount instead, it will sit up higher.

lilshawn:


--- Quote from: syph007 on May 19, 2010, 01:49:35 pm ---It's probably bottom mounted right?  Top mount instead, it will sit up higher.

--- End quote ---

ya, if you want to end up on crapMAME.

in the humble words of crapMAME:


--- Quote ---And of course, exposed plates still suck.
--- End quote ---


Pages: (1/2) > >>

Go to full version