| Main > Main Forum |
| Received my new panel, but need a little help |
| (1/2) > >> |
| shateredsoul:
So when I place the joystick over the wood (3/4") just too see how it looks and the happ 8 way sticks out but not as much as i'd like it to stick about as much as in this joysticks but when I place it to test it out, it sticks only enough for the rubber part to stick out, how can I make it more like in the pic? |
| TheGameFan:
If I'm reading you're question correctly, the answer is that you need to route a groove for the base in the bottom of the CP. THis will bring the stick higher. Also, there is a spacer that you cna use to raise it a bit. |
| DashRendar:
--- Quote from: shateredsoul on May 18, 2010, 08:22:57 pm ---So when I place the joystick over the wood (3/4") just too see how it looks and the happ 8 way sticks out but not as much as i'd like it to stick about as much as in this joysticks but when I place it to test it out, it sticks only enough for the rubber part to stick out, how can I make it more like in the pic? --- End quote --- Holy run-on sentence, Batman! Throw some punctuation in there! :lol |
| syph007:
It's probably bottom mounted right? Top mount instead, it will sit up higher. |
| lilshawn:
--- Quote from: syph007 on May 19, 2010, 01:49:35 pm ---It's probably bottom mounted right? Top mount instead, it will sit up higher. --- End quote --- ya, if you want to end up on crapMAME. in the humble words of crapMAME: --- Quote ---And of course, exposed plates still suck. --- End quote --- |
| Navigation |
| Message Index |
| Next page |