Main > Main Forum
Plexi on the CP
<< < (2/7) > >>
WBHarrison88:

--- Quote from: ids on May 14, 2010, 07:14:44 pm ---5/8" plywood?  Sorry, just being an a**  :)

--- End quote ---

We are all Entitled too be :)
ids:
Thanks, please let my wife know.

To be honest, I've been contemplating the same issue (for about 2 years).  Not sure if the local homeDespot etc has 5/8" mdf, so I may go with the plywood...will probably be a few months before I have to decide.  If you find a good solution, please post.

thx
WBHarrison88:
HA! I hear ya man.

I'll let you know if i run by something
Beretta:
i'd just stick with the 3/4th slap the plexi on top and then use carriage bolts to hold the edges down.. if needed.. small CP's wont need any help.

lot of people on here will disagree with this, but thats their problem not yours.

it's up to you.. personally it does'nt bother me this is generally what i seen in the arcades.
WhereEaglesDare:
the one that came on my cab sat ontop of the cp and was exposed on the sides as it was 3/4 board. the panel was 40x15 so the buttons and joysticks i guess werent enough, there was screws spaced through out the border.
Navigation
Message Index
Next page
Previous page

Go to full version