Main > Main Forum

Plexi on the CP

Pages: << < (4/7) > >>

EwJ:

see here

WBHarrison88:


--- Quote from: RandyT on May 14, 2010, 09:32:12 pm ---Offset the slot in the 3/4" MDF by 1/8" toward the side you plan to put the plexi on.  Then hit the edge with some black paint before you apply the T-Molding.  You'll never notice the 1/8" black edge below the molding (unless you are looking for it, of course) and your plexi will be seated in the molding like you want.

RandyT



--- End quote ---

Good thinking!

and thanks EwJ for the Link!

That shall solve my problem :)

MaximRecoil:

Buy 7/8" T-molding for the control panel.

Blanka:

Vandiktebank?

syph007:

If you like routing, you could also route off 1/8" from the entire board... wouldnt be the fastest solution, but it's possible.

Pages: << < (4/7) > >>

Go to full version