| Main > Main Forum |
| Plexi on the CP |
| << < (4/7) > >> |
| EwJ:
see here |
| WBHarrison88:
--- Quote from: RandyT on May 14, 2010, 09:32:12 pm ---Offset the slot in the 3/4" MDF by 1/8" toward the side you plan to put the plexi on. Then hit the edge with some black paint before you apply the T-Molding. You'll never notice the 1/8" black edge below the molding (unless you are looking for it, of course) and your plexi will be seated in the molding like you want. RandyT --- End quote --- Good thinking! and thanks EwJ for the Link! That shall solve my problem :) |
| MaximRecoil:
Buy 7/8" T-molding for the control panel. |
| Blanka:
Vandiktebank? |
| syph007:
If you like routing, you could also route off 1/8" from the entire board... wouldnt be the fastest solution, but it's possible. |
| Navigation |
| Message Index |
| Next page |
| Previous page |