Arcade Collecting > Pinball
Pinball admin buttons... which is the ground post?
Dazz:
Thanks for the input guys. I didn't have my DMM at the time and wasn't able to check continuity on the buttons. I stripped a piece of wire that I use for ground and threaded it in all of the middle legs and soldered it. The bottom legs are the NO posts just incase anyone else has to wire these.
lilshawn:
--- Quote ---The bottom legs are the NC posts just incase anyone else has to wire these.
--- End quote ---
uhm...don't you mean "normally open"?
as in when you push the button the contact between the middle and lower is established.
Dazz:
--- Quote from: lilshawn on May 03, 2010, 09:21:52 am ---
--- Quote ---The bottom legs are the NC posts just incase anyone else has to wire these.
--- End quote ---
uhm...don't you mean "normally open"?
as in when you push the button the contact between the middle and lower is established.
--- End quote ---
You are correct. I was thinking NO, but put NC for some reason.
Navigation
[0] Message Index
[*] Previous page
Go to full version