| Main > Main Forum |
| What would be the best way for me to fill in button holes in this situation? |
| << < (5/5) |
| nitz:
--- Quote from: Marsupial on May 01, 2010, 02:10:25 am ---no matter what you use, you need to sand it afterward. You start low grit (50?) but climb up to when you are satisfied. And take pics of the process, its always fun to have pictures! --- End quote --- --- Quote from: 92greenyj on May 01, 2010, 02:14:09 pm ---Bondo for sure. Thats what I use at my arcade i work for to fix stuff like that. When our games all first arrived, our Smokin Token unit was beat up from shipping. one of the bottom corners had been totally busted apart. So we went over to ACE hardware and got a tub of bondo and some white spray paint. few hours later it looked good as new and even now, 10 months later, you can't tell anything was ever wrong with that front corner --- End quote --- Sounds good! I'm in the planning stages of my cab refurb right now, and I think I might do my CP rebuild before I get around to filling in these holes and the chipped out wood. But I'll definitely post some pics in this thread when I get to it! :) |
| Navigation |
| Message Index |
| Previous page |