Main > Main Forum

Y-Plus Controller

Pages: << < (5/11) > >>

Hoopz:

You bet you can. 

http://ultimarc.com/mp_inst.html

As you can see, the different harnesses connect at different places on the Mini-pac.

D_Harris:


--- Quote from: Hoopz on April 25, 2010, 07:39:11 pm ---You bet you can. 

http://ultimarc.com/mp_inst.html

As you can see, the different harnesses connect at different places on the Mini-pac.

--- End quote ---

I guess you missed the couple of times I mentioned that I have the older version of the Mini-PAC. (See pic).

Darren Harris
Staten Island, New York.

Hoopz:


--- Quote from: D_Harris on April 25, 2010, 09:03:25 pm ---
--- Quote from: Hoopz on April 25, 2010, 07:39:11 pm ---You bet you can. 

http://ultimarc.com/mp_inst.html

As you can see, the different harnesses connect at different places on the Mini-pac.

--- End quote ---

I guess you missed the couple of times I mentioned that I have the older version of the Mini-PAC. (See pic).

Darren Harris
Staten Island, New York.

--- End quote ---
No I saw that.   ::)

On your Mini-pac, the older version, I'm going to bet you can do the same thing.  The pins on the left side of your Mini-pac, the older version, are for the optical controls.  I'd be curious to see if you emailed Andy and told him you had the older version of the Mini-pac, if you can hook up both at the same time. 

Hoopz:

I do sincerely apologize for posting the wrong diagram.  It's clearly for the new Mini-Pac, not the old one.

It wasn't that hard to find the old one though. 

http://www.ultimarc.com/mp_inst_old.html

But then, I found it easy to find the prices that some others couldn't find.   ???

Hoopz:

Here's a quote from Andy (the owner of Ultimarc) where someone asked about the instructions.  This may help.


--- Quote from: AndyWarne on February 01, 2009, 04:31:49 pm ---Those are the correct adaptors. You should have had at least one cable with the Mini-PAC, this might be a PS/2 male-male which you can use.

Take a look at this:  http://www.ultimarc.com/Mini-PAC%20Manual1.pdf

This is an old manual which was written by someone else, and shows the older version of the board, but the wiring information might help.

Andy



--- End quote ---

Ironically, it was YOUR thread and YOUR question.  And as you can see, the pins that I referenced earlier are indeed the optical controls.

 :P

Pages: << < (5/11) > >>

Go to full version