Main > Main Forum
Daphne joystick mapping help
<< < (3/5) > >>
isucamper:

--- Quote from: Havok on April 19, 2010, 02:01:32 am ---If it doesn't register, then you're SOL.

--- End quote ---

I should have come in here sooner.  This isn't true. 

How many joysticks are on your system?  Go into Gamepads and see how many are registered.  Daphne will want to use the first one in the list.  However, you can make it use any one you want.

This is from memory... but try it out.  Go into your gamepad list in the control panel.  Highlight the GPWiz and click the "Advanced" button.  Set the preferred device to your GPWiz. 

Bam.  Daphne should see it.

The only thing Daphne can't do is use more than one gamepad device at once.  So if you have GPWiz and a flightstick, you can't have Daphne see them both.  Or, like on my system, I have my preferred device set as my U360, but then I don't get the admin buttons that are on my GPWiz.  I've got to use joy2key for those. 
Havok:

--- Quote from: isucamper on April 19, 2010, 12:14:21 pm ---
--- Quote from: Havok on April 19, 2010, 02:01:32 am ---If it doesn't register, then you're SOL.

--- End quote ---

I should have come in here sooner.  This isn't true. 
 

--- End quote ---

I should qualify my original statement; it depends in your setup and button requirements. I am speaking from experience, using a GPWiz.  My original setup with a GPWiz (and no other gamepad or joystick, just a keyboard encoder) would work great with the directionals, however would not map the buttons properly. It just wouldn't see some of the buttons.
isucamper:

--- Quote from: Havok on April 19, 2010, 01:45:20 pm ---
--- Quote from: isucamper on April 19, 2010, 12:14:21 pm ---
--- Quote from: Havok on April 19, 2010, 02:01:32 am ---If it doesn't register, then you're SOL.

--- End quote ---

I should have come in here sooner.  This isn't true. 
 

--- End quote ---

I should qualify my original statement; it depends in your setup and button requirements. I am speaking from experience, using a GPWiz.  My original setup with a GPWiz (and no other gamepad or joystick, just a keyboard encoder) would work great with the directionals, however would not map the buttons properly. It just wouldn't see some of the buttons.

--- End quote ---

Hmm... that could be.  Maybe it only recognizes buttons 1-16 or something. MAME actually has a little hiccup with buttons 14-16. 
mytymaus007:
Yes it only recognizes the button when i configure up and down i get nothing. Anyone else try this. Might have to get an ipac
Zebidee:
Check out this thread for setting up Daphneloader to work:

http://forum.arcadecontrols.com/index.php?topic=66957.0

It should work with default Mame keysettings - no need for joy2key etc. Only caveat is that I did this three years ago. I still use it today, but have not updated Daphneloader to the latest either.
Navigation
Message Index
Next page
Previous page

Go to full version