Main > Main Forum
How would you finish this??
reptileink:
I am going to be repairing the damaged wood with new MDF, and new t-molding, but I am unsure what to do with the cabinet. I really don't think this thing will hold up to trying to remove the laminate.
Was thinking of just scuffing it up real good and laying down some paint. Then, not full side art, but a couple bigger-sized graphics on each side.
:dunno
javeryh:
It is hard to tell from the pic but I'd just use some bondo to clean up all the dents and fix the bottom part that looks a little banged up. If the laminate won't come off I'd sand the crap out of it to get a nice smooth surface and re-laminate. Paint over laminate is going to look bad.
RayB:
I would ignore the back completely.
reptileink:
--- Quote from: RayB on April 15, 2010, 03:27:45 pm ---I would ignore the back completely.
--- End quote ---
yeah, I was thinking the same thing, but if it's already banged up, I'd rather fix it. I just feel that the banged up section is already weak, and any more bumps could just make it worse. Besides, I think that smaller back panel is just held in by "L" brackets, so it should be an easy fix.
Laminate huh???? Really don't want to go down that route($$$$)
Ginsu Victim:
--- Quote from: RayB on April 15, 2010, 03:27:45 pm ---I would ignore the back completely.
--- End quote ---
I agree.