Main > Main Forum
Attaching Plexi overlay from behind.
(1/1)
MajorHavoc:
I'm considering bypassing the typical CPO in favor of 1/8 inch plexi that has been sanded, primed and shot with automotive paint.  To keep the panel lines clean, I was thinking about affixing T-nuts to the reverse side of the plexi.  The plywood structure would be drilled to accomodate the t-nut shanks and would also be counter bored to compensate for the flanges of the t-nuts. The material would be held in place from underneath with appropriately sized button head screws and fender washers.  Any thoughts or suggestions would be more than welcome.
Navigation
Message Index

Go to full version