| Main > Main Forum |
| RGB Driver/Wires Question |
| (1/3) > >> |
| studmuff:
HI I got my order from GroovyGameGear.com today. I have question about the wires installed on the RGB Driver. Which wire is for what coming off the driver? I understand One is Red, Green, Blue & 5 Volts but don't know which is which. Also do I have to be aware which wire goes to what input terminal on the ledwiz? For example, to I have to be aware that the blue input for a certain driver goes to a specific input on the ledwiz? http://www.flickr.com/photos/36453841@N05/4455301833/# Thanks. |
| studmuff:
Any help greatly appreciated. ??? |
| RandyT:
From the top (position 1); Red (Ground or LED-Wiz Output) Green (Ground or LED-Wiz Output) Blue (Ground or LED-Wiz Output) +5vDC I usually recommend connection to the LED-Wiz RGBRGBRGB....etc, starting with output number 1. Most software out there doesn't care, though, so you can wire them the way it suits you best. RandyT |
| studmuff:
--- Quote from: RandyT on March 23, 2010, 12:44:37 am ---From the top (position 1); Red (Ground or LED-Wiz Output) Green (Ground or LED-Wiz Output) Blue (Ground or LED-Wiz Output) +5vDC I usually recommend connection to the LED-Wiz RGBRGBRGB....etc, starting with output number 1. Most software out there doesn't care, though, so you can wire them the way it suits you best. RandyT --- End quote --- Thanks Randy. :) |
| studmuff:
Just had some other questions about the LED-Wiz and wiring. I have wired my LED RGB Driver wires to the outputs on The LED WIzs. I have a total of 8 buttons (24 ouputs) on Dev 1, 8 buttons (24 outputs) Dev 2 & 7 buttons (21 Outputs) on Dev 3. I wired all the 5 volt wires together and placed in the USB 5V Output for each device. Questions: 1. DO I have to use the External Ground? I figure I don't since I'm not running any power off the computer power supply (just the USBs will be powering them). 2. Do I have to concerned with the "Bank Voltage Select" terminals? I'm not sure about this. Since I'm only running the drivers off the USB power do I need to wire these terminals? 3. DO I have to link the devices to each other via wires or are they linked via software aka LEDBlinky, etc.? Thanks. Tom. |
| Navigation |
| Message Index |
| Next page |