Main > Main Forum

How to cut cp overlay from mamemarquees?

Pages: << < (2/2)

mwong168:

I cut my control panel overlay with an exactoknife once it was applied on my control panel.  I just felt by hand for the opening and the punched through the middle and cut my blade towards the outside edge and then just used it as a guide. 

FrizzleFried:


--- Quote from: Nation on March 15, 2010, 02:06:49 pm ---Thank for the tips guys! I love this site.  Same technique for the 3" trackball hole as well? From what I read the ultimarc trackball is pretty snug. I might need to enlarge the hole ever so slightly with a file I guess.

--- End quote ---

With the trackball you're going to want to install the overlay first... then use an exacto knife to cut out the hole using the hole in the wood/metal control panel as a guide.



Hoopz:


--- Quote from: FrizzleFried on March 15, 2010, 02:21:34 pm ---
--- Quote from: Nation on March 15, 2010, 02:06:49 pm ---Thank for the tips guys! I love this site.  Same technique for the 3" trackball hole as well? From what I read the ultimarc trackball is pretty snug. I might need to enlarge the hole ever so slightly with a file I guess.

--- End quote ---

With the trackball you're going to want to install the overlay first... then use an exacto knife to cut out the hole using the hole in the wood/metal control panel as a guide.



--- End quote ---
Yes, yes.

Pages: << < (2/2)

Go to full version