| Main > Main Forum |
| How to cut cp overlay from mamemarquees? |
| << < (2/2) |
| mwong168:
I cut my control panel overlay with an exactoknife once it was applied on my control panel. I just felt by hand for the opening and the punched through the middle and cut my blade towards the outside edge and then just used it as a guide. |
| FrizzleFried:
--- Quote from: Nation on March 15, 2010, 02:06:49 pm ---Thank for the tips guys! I love this site. Same technique for the 3" trackball hole as well? From what I read the ultimarc trackball is pretty snug. I might need to enlarge the hole ever so slightly with a file I guess. --- End quote --- With the trackball you're going to want to install the overlay first... then use an exacto knife to cut out the hole using the hole in the wood/metal control panel as a guide. |
| Hoopz:
--- Quote from: FrizzleFried on March 15, 2010, 02:21:34 pm --- --- Quote from: Nation on March 15, 2010, 02:06:49 pm ---Thank for the tips guys! I love this site. Same technique for the 3" trackball hole as well? From what I read the ultimarc trackball is pretty snug. I might need to enlarge the hole ever so slightly with a file I guess. --- End quote --- With the trackball you're going to want to install the overlay first... then use an exacto knife to cut out the hole using the hole in the wood/metal control panel as a guide. --- End quote --- Yes, yes. |
| Navigation |
| Message Index |
| Previous page |