Main > Main Forum

Plexi Glass on CP's...

Pages: << < (2/2)

Epyx:

Agreed on the 3mm (1/8") or greater..not thinner.

Also make sure you use a router to flush trim around the edge...don't try to score it by hand as it is too prone to errors.  Use a smaller drill bit to create a pilot hole (buttons/joys) and then flush trim to prevent cracks.

Ginsu Victim:


--- Quote from: Franco B on March 15, 2010, 12:01:04 pm ---Your buttons should hold it down presuming you are using the nut type, you shoudn't need to use mounting screws etc.

--- End quote ---

+1

I only have the buttons holding mine down and it's worked fine for the last two years.

Epyx:


--- Quote ---+1

I only have the buttons holding mine down and it's worked fine for the last two years.
--- End quote ---

+2

Same with laminate...buttons are usually fine and the edge is held in place with the T Molding and that is all you really need.

Pages: << < (2/2)

Go to full version