| Main > Main Forum |
| Plexi Glass on CP's... |
| << < (2/2) |
| Epyx:
Agreed on the 3mm (1/8") or greater..not thinner. Also make sure you use a router to flush trim around the edge...don't try to score it by hand as it is too prone to errors. Use a smaller drill bit to create a pilot hole (buttons/joys) and then flush trim to prevent cracks. |
| Ginsu Victim:
--- Quote from: Franco B on March 15, 2010, 12:01:04 pm ---Your buttons should hold it down presuming you are using the nut type, you shoudn't need to use mounting screws etc. --- End quote --- +1 I only have the buttons holding mine down and it's worked fine for the last two years. |
| Epyx:
--- Quote ---+1 I only have the buttons holding mine down and it's worked fine for the last two years. --- End quote --- +2 Same with laminate...buttons are usually fine and the edge is held in place with the T Molding and that is all you really need. |
| Navigation |
| Message Index |
| Previous page |