| Main > Main Forum |
| Plexi Glass on CP's... |
| (1/2) > >> |
| Si the Sigh:
...is 1.5mm ok? Or is that too thin? ??? |
| severdhed:
i used 1/8" plexi on mine, which i beleive comes out to just over 3mm and it works just fine. i'd be a little concerned with the thinner stuff being too flexible..but it really depends on how you are doing it. if the Tmolding covers the edge of the plexi, then it should be fine. if the plexi sits above the t-molding, i'd be afraid of it getting caught on clothing and getting pulled up. |
| Si the Sigh:
Thanks. Yea, Plexi on mine will be above the t-moulding. Going to have to think of a good way to secure it, as I don't want it too thick, but also don't want to crack it when securing. |
| Ginsu Victim:
Mine is 1/8" and it's just right for my needs. I could go thicker, but never thinner. |
| Franco B:
+1 more for 3mm. Your buttons should hold it down presuming you are using the nut type, you shoudn't need to use mounting screws etc. |
| Navigation |
| Message Index |
| Next page |