Main > Main Forum

Yet, another Star Wars Post... Need help

Pages: (1/3) > >>

H4CK3R:

First off I did search, and maybe not enough..... But

I have a Star Wars cab, with Yoke, connected thur a A-pac.  After calibrating the "ultramarc game controller"  It seems the Y axis is really sensitive.  It jumps all over the place.

at Dead Center,  X =   247    Y = 2161
at Left Up,,        X = 2123    Y = -770 to -870  Keeps jumping
at Right Down,    X = -1920    Y = 2175

Seems the Y is way off...  at center its at 2161 to Down its at 2175.  Only 14 points off...  Thus is why its sooo jumpy in the game.  is there anyway to over ride the dead center point withen the the calibration?

What am I missing here?

H4Ck3R


H4CK3R:

Figured it out... seems the POT is going out...  I was looking at the new SW yokes, and he sells the pots, tho i am not sure what ones to get... the 5k or the 120k?  what would be better?

H4CK3R

Havok:

5K replaces what is in there. The 120K is if you were to hack the yoke to connect to a PC joystick port.

H4CK3R:

Replaced the POT... Still the same issue.

dead center Y is at 2170 and at full up its at 2176.   Only 6 degree's off...

Just weird that its jumps really fast at the very bottom and top, but not steady in the middle.  is there a A-pac Config app?  Or a way to over ride the data settigns so that it get a full flowing motion for the y axis?

H4CK3R

SavannahLion:

Take the pot out of the yoke and twist it with your hands to see what kind of numbers you get. Narrow the problem to a defective pot, an incorrect installation, a problem with the gears, or a PEBKAC error.

Pages: (1/3) > >>

Go to full version