Main > Main Forum
Wiring LEDs with Minipac and harness?
(1/2) > >>
korbitz:
Okay read some threads about people adding LEDs to their minipac but cant find any posts about how it is done.

Currently i am using the minipac with the harness, i also have a cpl LEDs kicking about and would like to make a use out of them.

Any help would be appreciated

p.s. my wiring skills aren't the greatest so non-layman terms would be appreciated
BobA:
I think it depends on which minipac you have.  The early ones had a header that was like the one on the ipac for keyboard leds.  Looking at the new wiring diagram I do not see this header on the newer minipacs.
korbitz:
The version i have isn't the same as the one displayed on the website, it has a row of 9 pins in 2's going vertically as opposed to horizontally for the harness.

So are these pins used as keyboard LEDs? with the diagram i got with the board, there was nothing on the diagram about these pins.
BobA:
I think the old minipac header was the same as the one on the ipac. 
surface tension:
If you want to run LEDs from the minipac, just use the 5V with a resistor. There are 3 x 5V connections on the new one but it doesn't have connections for keyboard LEDs.

I'm not sure how many you can get away with but you can certainly run a couple off it. I use one on the trackball.
Navigation
Message Index
Next page

Go to full version